Date sent:        Tue, 25 Jun 1996 19:00:52 -0700
To:               offroad@off-road.com
From:             Ian Staines 
Subject:          Steering knuckle bearings
Send reply to:    offroad@ai.gtri.gatech.edu

>I beat on the nuckle arm and cones till my
>hammer was smoking!  After both I and the hammer cooled off I jammed two
>nuts together and pulled the studs. 

My wife was out of town this week, so I was beating my hammer till it was
smokin' too, but I never had enough courage to jam my nuts together and pull
my studs at the same time!

---
Toyota Land Cruiser WWW page 
                 Richmond, BC  Canada



Date sent:        Tue, 25 Jun 1996 22:37:27 -0400
To:               offroad@ai.gtri.gatech.edu
From:             Joe Attardo 
Subject:          Re: Steering knuckle bearings
Send reply to:    offroad@ai.gtri.gatech.edu

>My wife was out of town this week, so I was beating my hammer till it was
>smokin' too, but I never had enough courage to jam my nuts together and pull
>my studs at the same time!
>
>---
>Toyota Land Cruiser WWW page 
>                 Richmond, BC  Canada


Perfect!  Just perfect.  Now when you rebuild your engine, don't forget
to polish your rod. Or maybe instead of lifting the TLC, you could just
jack it up and crank it a few times.  

Joe Attardo (laughing hard)
jca115@psu.edu

If you have any question, remark, comment, want to share some philosophy or just want to express your opinion about these pages, feel free to send email to: w.j.markerink @ a1.nl